Table of Contents
Advertisement
10
RANDOM
SELECTION
OF SLIDES
IN TRAYS
To project a particular slide in a tray:
1,
2.
3.
Press the SELECT BAR firmly and hold it down.
Rotate the tray until the number of the slide you want to
project is opposite the gate index on the projector.
Release the select bar; the desired slide will be pro-
jected immediately.
REMOVING
SLIDE TRAY
i.
2.
3.
With
the projector turned
on,
press
the SELECT
BAR
firmly and hold it down.
Rotate the tray until the tray index bar is opposite the
gate index.
Release the select bar and then lift off the tray.
SHOWING
SINGLE
SLIDES
1.
With the projector turned on, insert a slide (correctly
oriented) into the projector gate. Push the slide down
into the gate as far as it will go.
. After viewing the slide, press the SELECT BAR to eject the
slide from the gate. You can now insert another slide
into the gate. (Slides up to 1% inch thick can be pro-
jected by this method.)
AFTER THE SHOW
1.
2.
3.
Remove the tray; then slide the power switch to OFF.
Lower the front of the projector by turning the elevating
wheel. Retract the leveling foot.
Retract the lens by turning the focus
knob counter-
clockwise.
. Unplug the power and remote-control
cords. Fold the
power cord in about 4-inch lengths and place it in the
cord
compartment.
Fold the remote-control
cord
by
placing the ends together and folding it in about 4-inch
lengths. Place it in the cord compartment.
SELECT
BAR
Advertisement
Table of Contents
