Installing A Memory Module - Toshiba Satellite A305-S6825 Resource Manual

Installing a memory module

Memory modules can be installed in the memory module slots on
the base of the computer. You will need a small Phillips screwdriver
for this procedure.
The computer has two memory slots—Slot A and Slot B. You can
install one or two memory modules.
If the computer is on, begin at step 1; otherwise, skip to step 3.
1 Click Start, and then click the arrow next to the lock button in
the lower-right corner of the Start menu.
The Shut Down menu appears.
Start
(Sample Image) Shut Down menu
If the computer has been running recently, the memory module may
be hot. The surrounding area may also be hot. Allow the module to
cool to room temperature before replacing it. Avoid touching the
cover, the module, and the surrounding area before they have cooled.
Failure to follow these directions could result in minor bodily injury.
To avoid damaging the computer's screws, use a small Phillips
screwdriver that is in good condition.
Installing a memory module with the computer's power on may
damage the computer, the module, or both.
Before you install or remove a memory module, turn off the computer
using the Start menu. If you install or remove a memory module
while the computer is in Sleep or Hibernation mode, data will be lost.
For this model Slot A is the bottom slot. Slot B is the top slot. If only
one memory module is to be installed, it must be installed in slot A.
Adding memory (optional)
Arrow
Shut Down Menu
27