Table of Contents
Advertisement
26
EN
Edit To O r
From Another
V ideo
Recorder
N U M BER "0"
IM PO RTAN T:
● To edit, both the player and the recorder must be of the
same colour system. Press your recorder's CO LO U R
SYSTEM button to select the appropriate colour system.
● For more information on multi-system compatibility,
pg. 28.
TV Receiver
VIDEO
CHANNEL
RF Cable (provided)
Recorder
Downloaded from:
https://www.usersmanualguide.com/
1
2
3
2
4
5
6
7
8
9
0
4
TV PRO G
1
Your recorder
Player
AV Cable
(not provided)
Another recorder
You can use your video recorder as the source player or the
recording deck.
MAKE CO N N ECTIO N S
1
Connect the player's AUDIO/VIDEO OUT connector to
the recorder's AUDIO/VIDEO IN connector.
SET RECO RDIN G DECK' S
IN PUT MO DE
2
Set to AUX. With this video recorder, press N U M BER
key "0" and/or TV PRO G to select depending on the
connector being used — "L-1" for the rear panel
AUDIO/VIDEO input connectors, or "F-1" for the front
panel AUDIO/VIDEO input connectors.
SELECT " EDIT" FO R PICTURE
CO N TRO L SET MO DE
3
Follow the "Picture Control" section on page 15, then
select "EDIT."
N O TE:
When you select "EDIT" to dub tapes, be sure to select
"AUTO" (or "NORM" when the B.E.S.T. function is set to
"OFF") after you finish dubbing the tapes.
ST ART SO URCE PLAYER
4
Engage its Play mode.
ST ART RECO RDIN G DECK
5
Engage its Record mode.
N O TES:
● All necessary cables can be obtained from your dealer.
● When you use this recorder as the player for editing, be sure
to set "O.S.D." to "OFF" before starting (
● NTSC tapes being played back in the NTSC [ PAL mode
(
pg. 29) cannot be dubbed to another recorder.
● When you dub an NTSC tape using your recorder as the
playback deck, select NTSC 3.58 (or NTSC 4.43) with the
CO LO U R SYSTEM button (
Your recorder
Recorder
AV Cable
(not provided)
Another recorder
ED ITIN G
pg. 8).
pg. 28).
TV Receiver
VIDEO
CHANNEL
RF Cable
(provided)
Player
Advertisement
Table of Contents
