Advertisement
Note:
The unit's power supply is secondarily connected. Note
following.
te
toe
;
:
The unit is not completely disconnected from the mains as
long as the power cord is connected to a wall outlet.
Observera:
Apparatens strOmf6rsdrjning kopplas fran sekundart. V.g.
ge akt pa fdljande.
Apparaten frankopplas inte helt och hallet fran str6mnatet
medan
apparatens
n&atsladd
4r ansiuten
till vaxel-
stromsuttaget.
Bemeerk:
Stra@mmen til apparatet afbrydes p& den sekundare side.
Vear opmeerksom pa felgende.
Denne enhed er ikke fullstendig koblet fra lysnettet sa lenge
stikket er tilsiuttet stikkontakten.
Anmerkning:
Stro@mmen til apparatet er slatt av pa sekundeersiden. Veer
oppmerksom pa det falgende.
Dette apparatet koples ikke fullstendig fra nettet sa lenge
stgpselet star | en stikkontakt, selv om str@mbryteren settes
i av-stilling.
Huom:
Virta yksikk6Gn on kytketty pois sekundaaripuolelta. Huo-
miol seuraava.
Tama yksikk6 ei ole kokonaan kypketty pois pad virranjaka-
jasta kun pad katkaisin on liitettyna virtatiiriin.
,
For the U.S.A.
FCC WARNING:
This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference
unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if
an unauthorized change or modification is made.
_
te
hare
2
=
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment may
cause harmful interference to radio communications, if it is not installed and used in accordance with the instructions. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
For CANADA
DOC REGULATION
"THIS DIGITAL APPARATUS DOES NOT EXCEED THE CLASS B
LIMITS FOR RADIO NOISE EMISSIONS FROM DIGITAL APPARA-
TUS AS SET OUT IN THE RADIO INTERFERENCE REGULATIONS
OF THE CANADIAN
DEPARTMENT
OF COMMUNICATIONS."
GE-7030
(En)
19
Advertisement
