Advertisement
Creation of desired equalizer patterns
PARAMETRIC:
This mode allows to create a curve for up to three ranges centered around the user-selected
frequencies in the low-, medium- and high-frequency ranges. The inclination of each curve can
be selected between WIDE (gentle slope) and NARROW
(steep).
GRAPHIC:
This mode
allows to adjust the equalizer curve for each frequency
band provided. The curve
created in the parameter mode can be fine-adjusted in this mode.
M@ Adjusting curves centered around user-selected frequency ranges
(Parametric mode)
BF adjust the level.
1 Select the EQ.ON
mode.
7 EQ EFFECT
DISPLAY
Lights up.
160 @
FSO le 280068 hd
Cle 82S Ce Ck
os
68
@ Pressing the FLAT key allows to start adjustment from the flat
level position.
6 Select the inclination of the curve.
, 2 Select the parametric mode.
WIDE /
NARROW
Wipe) arrow]
One of the two
shall light up.
Wide and NARROW
alternates every
time the key is pressed.
GRAPHIC/
PARAMETRIC
Lights up.
+
98
*
40
6
230
WIDE
*
40
¢
BD
©
th
63
°+ 98
+
10
©
230
«© 46>
6
O26
«© 1k
NARROW
3 Select the frequency range.
@ One adjusted, the curve remains the same until next time it is
pressed,
ye ee =
F1 indicator 2
F2 indicator
vi When
the adjustments of ranges F2 and/or |
F3 are also required,repeat
steps 3 to 6 for |
each of them.
}
F3indicator
e@ VVhen two or three curves have been set, the overall curve
obtained by combining them is displayed in a few seconds.
| 4. Select the center frequency.
_—*
Low m seouene inv, High
ep
JAH Z
anion
ee
a
i
i
A
ee ee
ee
e@ For finer adjustment. perform the graphic mode operation
described in the following page.
12.
GE-7030
(En)
Advertisement
