Table of Contents
Advertisement
m@ Programming operation
tion.
10)
LEARN
USE
—_—
Position the remote control unit containing the sig-
nal to be programmed and the RC-140 so that their
transmitters face each other.
® The distance between the remote control units is about 2
to 5cm (13/16' to 2').
Press one of the RC-140's "learning" keys to be
used to program the signal.
@ The LEARN indicator lights up.
Within 30 seconds after pressing the "learning"
key, press the key of the other remote control unit
containing the signal to be programmed.
Programming is complete when the lighted LEARN indica-
tor goes out after blinking twice.
Hold the key of the other remote contro! unit depressed
until the LEARN indicator goes out.
To program another remote control signal, repeat steps 2
to 4 again.
Notes:
ile
TRANSMIT
AUDIO
AUX
——_—P
Place two heads in a close distance
Other remote
control unit
2to5cm
Lights up
Transmitted
4. The LEARN indicators goes out 30 seconds after a "learning"
(programmable)
key is pressed.
After this, programming
is
impossible.
To continue
programming,
press
the "learning"
(programming) key again.
_ When
two or more
"learning" keys are pressed at the same
nals or specially-coded
signals cannot
be programmed.
Pro-
gramming
is also
impossible
when
the
RC-140's
memory
capacity becomes full.
KC-991 (En)
19
Advertisement
Table of Contents
