Table of Contents
Advertisement
Specifications
A
Caution: Read this page carefully to ensure safe operation.
Performance
Input Sensitivity
PHONO.
TUNER/TAPE/CD/VIDEO.
Signal-to-Noise Ratio (IHF-A)
PHONO.
TUNER/TAPE/CD/VIDEO..
Phono Maximum Input Level.
Total Harmonic Distortion
20 Hz to 20 kHz.
Loudness Control.
Graphic equalizer control
(60 Hz, 150 Hz, 400 Hz, 1 kHz, 2.4 kHz,
6 kHz, 15 kHz).
Output Voltage and Impedance
Tape REC.
PRE OUT.
General
Power Consumption.
AC outlets
SWITCHED.
Dimensions.
Weight (Net)
2.5 mV/47 kQ
200 mV/47 kQ
80 dB for 2.5 mV input
101 dB
100 mV, T.H.D. 0.3% at 1 kHz
0.005% at rated output
+8 dB at 100 Hz (at -30 dB VOLUME Level)
+10 dB
200 mV/220Q
1 V/2.2 kQ
15 W
For USA and Canada: 2; (Total 680 W, 5.6 A max.)
For other countries: 2; (Total 420 W)
W: 440 mm (17-5/6")
H:
85 mm ( 3-3/8")
D:
277 mm (10-7/8")
3.8 kg (8.4 lb)
KENWOOD follows a policy of continuous advancements in development. For this reason specifications may be changed without notice.
For CANADA
DOC REGULATION
"This digital apparatus does not exceed the CLASS B limits for radio noise emissions from digital apparatus as set out in the radio interference
regulations of the Canadian department of communications."
For the U.S.A.
FCC WARNING:
This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference
unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an
unauthorized change or modification is made.
NOTE:
This equipment has been tested and found to comply with the limits for a CLASS B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment may cause harm¬
ful interference to radio communications, if it is not installed and used in accordance with the instructions. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the follow¬
ing measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
22
KC-991 (En)
Advertisement
Table of Contents
