Table of Contents
Advertisement
also interrupted when the saucepan is removed
from the cooking zone (the
shown on the display). If the cookware
recognition function is activated in spite of the
saucepan or frying pan on the cooking zone
being smaller than the zone itself, only the
necessary energy will be transmitted.
Protection from overheating
If the hob is used on full power for a long
period, the electronics will have trouble cooling
down if the room temperature is high. To avoid
excessively high temperatures forming in the
electronics, the power to the cooking zone is
reduced automatically.
Residual heat
If the cooking zone is still hot after being
switched off, the
on the display. The symbol clears once the
temperature drops below 60°C.
Heating accelerator
Each cooking zone is equipped with a
heating accelerator that allows the
maximum power to be delivered for a
time that is proportional to the selected
power.
This function allows the selected power to be
achieved in the shortest amount of time.
1. Turn the knob anticlockwise to position A
and then release it. The display shows the
symbol.
2. Select the required heating power (1..8)
within 3 seconds. The selected power and
the
symbol will flash alternately on the
display.
The power level can be increased at any
moment. The "maximum power" period will
automatically be modified. Once the
acceleration period is over the power level will
remain the same as the one previously selected.
If the power is reduced, by turning the
knob anti-clockwise, the heating
accelerator will automatically be
disabled.
974779931/A
symbol will be
symbol will be displayed
Keep warm
The Keep warm function allows you to
keep cooked food warm.
To activate the Keep Warm function turn the
knob of the required zone to an intermediate
position between 0 (off) and power level 1, until
the
symbol appears on the corresponding
display.
Booster function
The booster function allows the cooking zone to
be activated at maximum power for as long as
5 minutes. It can be used to bring a large
quantity of water to a boil rapidly or to broil
meat.
• To activate the Booster function, turn the
knob clockwise to position P, keep it there
until the
symbol appears on the
corresponding display and then release the
knob.
• After 5 minutes of continuous operation, the
Booster function will be disabled
automatically and cooking will continue at
power level 9.
• Select any other power level to deactivate
the Booster function.
Only for some zones: the Booster function is
always enabled and has to be disabled
manually using the corresponding knob.
The Booster function has priority over
the heating Accelerator function.
Hob power limitation
The induction hob is configured to operate at
7.4 kW, but it can be set to operate at 4.8 kW
or 3.7 kW.
1. Disconnect the appliance from the mains
power supply and wait 10 seconds before
turning the power back on.
The hob power limitation must be set
within 2 minutes of it being connected to
the mains power supply.
2. Turn both the front left and front right
cooking zone knobs anticlockwise to
position "A" at the same time, and keep
them in this position for 3 seconds.
fig. 4
The rear left and rear right cooking zone
displays indicate "7." and "4" (power 7.4 kW).
USE - 31
Advertisement
Table of Contents
