Operation - Ryobi OP4010 Operator's Manual

WARNING:
Do not allow familiarity with products to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
APPLICATIONS
You may use this product for the following purpose:
 Charging RYOBI 40 Volt lithium-ion batteries
NOTICE:
Charge in a well-ventilated area. Do not block charger
vents. Keep them clear to allow proper ventilation.
CHARGING
See Figure 1, page 7.
Battery packs are shipped in a low charge condition to
prevent possible problems. Therefore, you should charge
them before first use. If the charger does not charge your
battery pack under normal circumstances, return both the
battery pack and charger to your nearest repair center for
electrical check.
Charge time varies and is dependent upon the amp hour
capacity of battery pack.
 Make sure the power supply is normal household voltage,
120 volts, AC only, 60 Hz.
 Connect the charger to a power supply.
 Attach the battery pack to the charger by aligning the
raised ribs on the battery pack with the grooves in the
charger, then slide the battery pack onto the charger.
 Press down on the battery pack to be sure contacts on
the battery pack engage properly with contacts in the
charger.
 Latches should snap into place to ensure charger is
correctly connected.
 Do not place the charger in an area of extreme heat or
cold. It will work best at normal room temperature.

OPERATION

 The battery pack will become slightly warm to the
touch while charging. This is normal and does not
indicate a problem.
 To remove the battery pack from the charger, depress
latches and pull up on the battery pack.
 Fan will make a slight humming noise when the battery
is charging.
CHARGING A HOT BATTERY PACK
When using a tool continuously, the battery pack may
become hot. A hot battery pack may be placed directly
onto the charger port but charging will not begin until the
battery temperature cools to within acceptable temperature
range. When a hot battery pack is placed on the charger,
the charger will activate cooling. When the battery pack
cools, the charger will automatically begin charging.
CHARGING A COLD BATTERY PACK
A cold battery pack may be placed directly onto the charger
port but charging will not begin until the battery temperature
warms to within acceptable temperature range. When a cold
battery pack is placed on the charger, the charger will display
that the battery is under temperature. When the battery pack
warms the charger will automatically begin charging.
SMART PHONE APP
Download the RYOBI Hyper Charger App from the Google
Play Store or Apple App Store for quick updates to remain-
ing charge status, helpful links and tutorials, and more from
your smart phone. This App connects to your charger via.
Bluetooth
®
PAIRING WITH BLUETOOTH
The Ryobi Hyper Charger App includes detailed instructions
on pairing the charger.
To pair the charger to a device:
 Connect the charger to a power supply.
 Push the POWER button to turn the LCD screen ON.
 Open the Ryobi Hyper Charger App on the device.
 Press and hold the " " button.
 The Bluetooth
luminated when pairing is sucessful.
LCD FUNCTIONS
See Figure 1, page 7.
Push the POWER button to turn the LCD screen On or OFF.
5 — English
.
indicator will change from blinking to il-
®
®