JVC GR-DVL100U Manual page 6

PAUSE
GEFFING STARTED (cont.)
Grip Adjustment
yf ScP2tate the Velcro sip.
6 J Pass your right hand through the loop and grasp
the grip.
Adjust so that your thumb and fingers can easily
'operate the Recording Starv/Stop Button and
Power Zoom Lever. Refasten the Velcro strip.
Viewtinder Adjustment
J Sette Power Switch to" or" 9" while
pressing down the Lock Button located on the
switch.
Jo 17 the Diopte Adjustment Control until the
indications in the viewfinder are clearly
focused
Shoulder Strap Attachment
1 Make sure the battery pack or DC cord is
removed. Following the illustration, thread the
strap through the eyelet ©, then fold it back and
thread it through the buckle @. Repeat the
procedure to attach the other end of the strap to
the other eyelet @, making sure the strap is not
twisted,
Tripod Mounting
5B Align the screw and camera direction stud on
the tripod with the camera's mounting socket
and stud hole, Then tighten the screw.
'*Some tripods are not equipped with studs.
CAUTION:
When using a tripod, be sure to open and
extend its legs fully to stabilize the
camcorder, To prevent damage to the unit
caused by falling over, do not use a small-
sized tripod.
MENU/BRIGHT Wheel
DISPLAY MENU
el]
Date/Time Settings
The date/time is recorded onto the tape at all times, but its
display can be turned on or off during playback
(F pg. 32).
Set the Power Switch to "MH" while pressing down
the Lock Button located on the switch. The power
lam
Press the MENU/BRIGHT wheel. The Menu Screen I)
appears
Rotate the MENU/BRIGHT wheel to select "
Press it and "DISPLAY MENU" appears.
Rotate the MENU/BRIGHT wheel to select "CLOCK
ADJ." Press it and "month" is highlighted.
Rotate the MENU/BRIGHT wheel to input the month.
Press it, Repeat to input the day, year, hour and
minute, Rotate the MENU/BRIGHT whee! to select
"-4RETURN, and press it twice, The Menu Screen
closes.
NOTE:
Even if you select "CLOCK AD).", if the parameter is not
highlighted the camcorder's internal clock continues to
operate. Once you move the highlight bar to the first date/
time parameter (month), the clock stops. When you finish
setting the minute and press the MENU/BRIGHT wheel,
the date and time begin operation from the date and time
you just set