Table of Contents
Advertisement
42
Clock Source
• You can select 'Off' , 'Pro:Centric' , 'TV' , 'NTP' , 'Admin' .
• NTP : Clock is synchronized using Network Time Protocol. It's only enabled when network cable is connected. (Depending on model)
• Admin : It's automatically set to Admin when clock is updated by commercial protocols like TVLink-HCEC, TVLink-Interactive, or HCAP API.
• Off : Clock is synchronized using any available clock source.
• Pro: Centric : Clock is synchronized using Pro:Centric server. (Depending on model)
• TV : Clock is synchronized using particular TV programme.
- Input (Depending on model)
» You can select 'Input' according to 'Clock Source' .
» You can select 'RF' or 'IP' when Clock Source is 'Pro:Centric' .
» You can select TV source when Clock Source is 'TV' .
» Input is set to 'None' , 'HCAP' , 'Protocol' , 'HTNG' automatically when Clock Source is 'Admin' .
- Programme / Frequency (Depending on model)
» Sets the Frequency to get the time information when Clock Source is 'Pro:Centric' .
» You can select programme when Clock Source is 'TV' .
- Timezone (City) / Timezone (Custom) / Timezone (Offset) (Depending on model)
» In the case when there is difference between the time information received from the Teletext and the time of the current area, it can
be set up to correct this. The initial value is 0, and it can be changed in the range of -12 Hrs ~ +14 Hrs. (Timezone (Offset) range is -12
Hrs ~ +12 Hrs)
Crestron
(Depending on model)
Crestron Connected
• The connection status of the server type shall be indicated by pictures and phrases. (Disconnected, Connecting, Connected)
• Type: You can select the server type you want to connect to (Off, Control System, Virtual Control, Fusion)
• CONNECT: If you press the button once, a set tries to connect to the server and the button phrase is changed into DISCONNECT. In this case, the upper
items are immutable. To disconnect and change upper items, pressing the button again is needed.
• Information for connecting with the server
- Type: Control System
» Server: Enter the IP information of the server
» Port: Enter the Port information for the server
» IP ID: A unique ID that distinguishes crestron equipment from server
- Type: Virtual Control
» Room ID: A unique ID that distinguishes room from server. If the IP ID is the same, but the Room ID is different, the server recognizes
it as a different crestron equipment.
» Server, Port, IP ID are the same as Control System's.
Advertisement
Table of Contents
