Samsung NX58M6630SS/AA-00 User Manual page 46

Troubleshooting
Problem Possible cause
Steam or smoke This is normal.
coming from
under the
control panel.
A burning This is normal for a new
or oily odor oven and will disappear
coming from within 1/2 hour of the
the vent. first bake cycle.
A strong odor. This is temporary.
Oven racks are This is normal.
difficult to slide.
Fan noise. This is normal.
The convection This is normal.
fan is not
working.
46 English
NX5000M_NX58M6650WS_AA_DG68-00993A-03_EN+MES+CFR.indb 46
Action
The oven vent is located there.
More steam is visible when you
use the convection functions or
when baking or roasting multiple
items at the same time.
To speed the process, set a self-
cleaning cycle for a minimum of
3 hours. (See page 39 and 40.)
The insulation around the inside
of the oven emits an odor the first
few times the oven is used.
Apply a small amount of vegetable
oil to a paper towel and wipe the
edges of the oven racks with the
paper towel. Racks become dull
and hard to slide if they are left in
the oven during a self-clean cycle.
The convection fan runs until the
function is over or the door is
opened.
The fan starts automatically when
the oven reaches the preheat
temperature.
Others
Problem Possible cause
The product is not The appliance has been
level. installed improperly.
The leveling leg(s) is (are)
damaged or uneven.
The kitchen cabinets are
not properly aligned and
make the range appear to
be not level.
The display goes The electrical outlet Ground
blank. Fault Interrupter (GFI or
GFCI) has been tripped and
needs to be reset.
Your digital control has
been damaged.
Food does not The wrong cooking mode is
bake or roast selected.
properly in the
The oven racks have not
oven.
been positioned properly
for the foods being cooked.
Incorrect cookware or
cookware of improper size
is being used.
The oven thermostat needs
adjustment.
There is aluminum foil
on the racks and/or oven
bottom.
The clock or timers are not
set correctly.
Action
Make sure the floor is level, strong,
and stable. If the floor sags or slopes,
contact a carpenter.
Check and level the range. (See the
Installation Instructions.)
Ensure that cabinets are square
and provide sufficient room for
installation.
Replace fuse or reset circuit breaker.
See page 22.
See page 24.
See page 16.
See page 32.
Remove foil.
See page 15.
2018-08-29 5:12:53