Kenwood DP-492 Instruction Manual page 14

Maintenance
@ Beware of condensation
When water vapor comes into contact with the surface of cold materi- _.
al, water drops are produced.
If condensation occurs, correct operation may not be possible, or the
unit may not function correctly.
This is not a malfunction, however, and the unit should be dried. (To
do this, turn the POWER switch ON and leave the unit as it is for several
hours.}
Before transporting or moving this unit, carry out the foliowing oper-
ations. ,
1. Turn the power ON but do not load a disc.
2. Wait a few seconds and verify that the display shown
appears.
3. Turn the power OFF.
14 pp-492 [En)
Ea a IE a I)
Be specially careful in the following conditions.
@ When the unit is brought from a cold place to a warm place, and
there is a large temperature difference.
@ When a heater starts operating.
@ When the unit is brought from an air-conditioned place to a place
of high temperature with high humidity.
When there is a large difference between the internal tempera-
ture of the unit and ambient temperature, or in conditions where
condensation occurs easily.
M@ Note related to transportation and movement
12 3 4 #5
6 7 8 9 0
1 «#12 «13 #14 «15
16 17 16 1 20
SINGLE TIME