Table of Contents
Advertisement
●
Secure the drive to the bay adapter bracket by installing four black M3 adapter bracket screws
through the sides of the bracket into the drive.
4.
Install four mounting screws into the sides of the drive (two on each side).
NOTE:
requires all silver mounting screws. HP has supplied four extra silver mounting screws installed on the
chassis next to the hard drives that are used when installing a hard drive in the upper drive bay. Refer to
Drives on page 30
hard drive in the lower bay, use the four silver and blue mounting screws that were removed from the
old drive to install the new drive.
●
If installing a hard drive in the upper (secondary) drive bay, use the extra silver mounting screws
that can be retrieved from the chassis next to the hard drive bays.
36
Chapter 4 Removal and replacement procedures – Microtower (MT) chassis
The lower hard drive bay requires silver and blue mounting screws. The upper hard drive bay
for an illustration of the location of the extra mounting screws. When replacing a
Advertisement
Table of Contents
