Kenwood KC-207 Instruction Manual page 12

GRAPHIC EQUALIZER control keys
KENWOOD stereo CONTROL AMPLIFIER KC-207
mm peer
C—_J
Cele
=a
we OD
ONISTAND BY
ON/DEFEAT
SS o-
DISPLAY switch
How to store the graphic equalizer patterns
This unit allows you to store in memory up to 5 equalizer pat-
terns for instant recall.
1. Press the DISPLAY switch to set the display to the graphic
equalizer mode.
2. Adjust the GRAPHIC EQUALIZER control keys to obtain the
desired equalizer pattern.
3. Press the MEMORY switch. The MEMORY indicator lights
up in the display.
4. Within approx. 5 seconds after pressing the MEMORY
switch, press the CALL switch to select the desired
equalizer channel (EQ-1 to EQ-5) in which you want to
store the equalized pattern.
5. Press the ENTER switch to store the equalized pattern in
memory.
6. To recall a preset equalizer pattern which has already been
stored, press the CALL switch.
12. Kkc-207 (Kk)
MEMORY switch
'GRAPHIC EQUALIZER ——_______-__,
CALL switch
ENTER switch
Display window
© Spectrum analyzer display:
To display, press the DISPLAY switch to change the display to
the spectrum analyzer mode.
It displays the output level to the LINE OUT jacks for each fre-
quency of the program source signal selected by the input
selector switches.
e Graphic equalizer display:
Press the DISPLAY switch to change the display to the
graphic equalizer mode.
Even while the spectrum analyzer display mode is activated,
the display shows the graphic equalizer mode for approx. 5
seconds in the following cases:
1. When the POWER switch is turned ON.
2. When any of the GRAPHIC EQUALIZER control keys is
pressed.
3. When the MEMORY switch is pressed.
4. When the CALL switch is pressed.
In these cases, approx. 5 seconds later, the spectrum
analyzer display will resume.