To Adjust Or Replace The Sparkplug - Craftsman 536.88626 User Manual

12. Fasten the bearing plates using
the four bolts removed earlier.
13. Make sure the hex shaft turns free-
ly.
14. Check the adjustment of the friction
wheel. See "How To Adjust The
Friction Wheel" in this section.
15. Make sure the friction wheel and the
disc drive plate are free from grease
or oil.
16. Install the bottom panel. See
Figure 28.
17. Tighten the bottom bolts on each
side of the bottom panel.
18. Install the top bolts on each side of
the bottom panel.
19. Cognect the spark plug wire.
HOW TO REPLACE THE AUGER
SHEAR BOLT
The augers are secured to the auger shaft
with special shear bolts. These shear bolts
are designed to break and protect the ma-
chine if an object becomes lodged in the au-
ger housing. Do not use a harder bolt as the
protection provided by the shear bolt will be
lost.
_lb ARNING: For safety and to
protect the machine, use only
original equipment shear bolts.
To replace a broken shear bolt, proceed
as follows. Extra shear bolts were pro-
vided in the assembly parts bag.
1. Move the throttle control to the stop
position. Disengage all controls.
2. Disconnect the spark plug wire.
Make sure all moving parts have
stopped.
3. Align the hole in the auger with the
hole in the auger shaft. Install the
new shear pin and spacer. See
Figure 33.
4. Connect the spark plug wire.
F-001088J
_ar Pin
/ I
_/ace r
_Figure 33
TO ADJUST THE CARBURETOR
If you think your carburetor needs ad-
justing, see your nearest Craftsman
Store. Engine performance should not
be affected at altitudes up to 7,000 feet.
For operation at higher elevations, con-
tact your nearest Craftsman Store.
IMPORTANT: Never tamper with the
engine governor, which is factory set for
proper engine speed. Over-speeding
the engine above the factory high
speed setting can be dangerous. If you
think the engine-governed high speed
needs adjusting, contact your nearest
Craftsman Store, which has the proper
equipment and experience to make any
necessary adjustments.
26
TO ADJUST OR REPLACE THE
SPARKPLUG
NOTE: This spark ignition system
meets all requirements of the Canadian
Interference-Causing Equipment Regu-
lations.
NOTE: This engine complies with all
current Australian and New Zealand
limitations regarding electromagnetic
interference.
If you have difficulty starting the snow
thrower, adjust or replace the spark
plug. Replace the spark plug is the
electrodes are pitted or burned or if the
porcelain is cracked. Follow the instruc-
tions below.
To adjust:
1. Clean spark plug by carefully
scraping the electrodes (Do not
sand blast or use a wire brush).