Advertisement
3.
To adjust tb{* chain between the engine drive and the
impel Lee,
a ftr loosen but do not remove the hardware hold¬
ing the bearing housing bracket to the frame.
Move the
bearing housing bracket down and to the rear to achieve
the proper chain tension.
Re^tighten ah hardware at this
time.
See Figure 14-
4,
Oil or grease all the chains and replace ail guards and
shields.
MAINTENANCE
LUBRICATION; There are four grease filtiny located on
the following;
1, Aide drive housing [right side).
2, Axle shaft (left side).
3, Auger drive pulley shaft
4, Auger drive sprocket shaft.
Apply general purpose automotive grease to all fittings every
15 hours of operation,
ENGINE CRANKCASE; See the engine manual. Drain the
crankcase by removing the plug on the rear lower side of the
side of the engine. Change oil every 25 hours of Operation-
Refill the crankcase to the top of the filler neck with 5W-20
grade MS motor oil.
GENERAL LUBRICATION; Apply light motor oil occas¬
ionally at the points indicated to reduce wear and assure
free movement.
Keep a light coating of oil on the auger
drive roller chains.
Figure 17
GENERAL REPAIRS: To prevent rusting, sand off and
paint any parts or areas which become chipped or damaged.
Tighten all fasteners and guard securely. Use a wire brush
to clean the auger drive roller chains before re-oiling.
SERVICE
SERVICE PARTS should be obtained through your
Simplicity dealer. He can give you better service if you will
take the Sno-Away identification {].Er} number with you.
SIMPLICITY MANUFACTURING CO..INC.
PORT WASHINGTON.
WlS»,
U~ S* A- !
Refer to i.d. no- when
writing or ordering parte.
The LD, number is on the right side of the frame just
ahead of the handles .
Thank you for studying this manual - with the know¬
ledge you now have your Sno-Away can SIMPLIFY your
life.
Vie want to add you to our long list of satisfied
Simplicity Owners.
PRODUCT SERVICE DEPARTMENT
SIMPLICITY MANUFACTURING COMPANY, INC.
9
Advertisement
