Connecting To Optional Equipment - Toshiba SD-590E Owner's Manual

Connections
Content of the output for each output jack is shown in the following table and differ depending on the On-Screen
Display Setting:
On-Screen Display Setting
"Video Out" HDMI Output
Setting Setting *
Composite Invalid
RGB Invalid
480/576p
720p
HDMI
1080i
1080p
* Settings for HDMI output format are performed using the HDMI button on the remote control or HDMI SELECT button
on the front panel.
Notes
• Both Composite (Video) and Scart (AV) will not have JPEG pictures output when HD JPEG Mode is on
480p/576p video resolution mode. You may view photos (JPEG ) through HDMI connection.
• If Auto is selected, it follows preference HDMI aspect ratio of TV.

Connecting to Optional Equipment

You can enjoy high quality dynamic sounds by connecting the DVD player to optional audio equipment.
• For connection to your TV, see "Connecting to a TV" .
• This section uses the following reference marks.
: Front speaker
: Rear speaker
: Sub woofer
: Center speaker
: Signal flow
Notes
• DO NOT connect the COAXIAL DIGITAL AUDIO OUT jack of the DVD player to the AC-3 RF input of a Dolby Digital Receiver. This
input on your A/V Receiver is reserved for Laserdisc use only and is incompatible with the COAXIAL DIGITAL AUDIO OUT jack
of the DVD player.
• Connect the COAXIAL DIGITAL AUDIO OUT jack of the DVD player to the "DIGITAL (COAXIAL)" input of a Receiver or Processor.
• Refer to the owner's manual of the connected equipment as well.
• When you connect the DVD player to other equipment, be sure to turn off the power and unplug all of the equipment from the wall
outlet before making any connections.
• The output sound of the DVD player has a wide dynamic range. Be sure to adjust the receiver's volume to a moderate listening
level. Otherwise, the speakers may be damaged by a sudden high volume sound.
• Turn off the amplifier before you connect or disconnect the DVD player's power cord. If you leave the amplifier power on, the
speakers may be damaged.
14
HD JPEG Mode: Off
Content of output for each output jack
HDMI Video AV
Output Output Output
- Composite Composite
- Composite RGB
480p/576p Composite Composite
720p Composite Composite
1080i Composite Composite
1080p Composite Composite
Warning
• When you are connecting (via the COAXIAL DIGITAL
AUDIO OUT jack) an AV decoder that does not have Dolby
Digital, Digital Theater Systems (DTS) or MPEG2 decoding
function, be sure to set "Digital Output" to "PCM" from the
on-screen displays. Otherwise, high volume sound may
damage your hearing as well as the speakers.
• When playing DTS-encoded discs (DVDs and audio CDs),
excessive noise may be output from the analog audio output
jacks. To avoid possible damage to the audio system, you
should take proper precautions when the analog audio output
jacks of the DVD player are connected to an amplification
system. To enjoy DTS Digital Surround™ playback, an
external 5.1 channel DTS Digital Surround™ decoder
system must be connected to the COAXIAL DIGITAL
AUDIO OUT jack of the DVD player.
HD JPEG Mode: On
Content of output for each output jack
during JPEG playback
HDMI Video AV
Output Output Output
- Composite Composite
- Composite RGB
480p/576p Composite Composite
720p -
1080i -
1080p -
-
-
-
, except
34