Changing The Settings Of The Function Buttons - Sony STR-D915 Operating Instructions Manual

For CD player i
Numeric buttons
DSKP
Search selectors ——SSC—~—'"~SC~*d Cd
[Skipsclections
[Pauseplay
st
a
Stop play ,
if you use Sony TV
When you press the VIDEO 1, 2, 3 (STR-D915 only), TV or
LD button, the power of the TV (VCR or LD player) is also
turned on.
When an LD player or VCR is selected, the input of TV
switches to VIDEO, and when TV is selected, the input of TV
switches to TV reception mode. (When you want to turn on
the power of TV and switch the TV input simultaneously,
keep pressing the button you have selected until its power is
turned on, or press the button again after the TV is turned
on.) ;
If the TV input does not switch to the appropriate mode,
switch the input signal by pressing the TV/ VIDEO button.
if you use TV most of the time (Only for Sony TV)
You set the remote to operate only the TV. Press the TV
CONTROL ON button. The remote buttons would work
only with TV. When you press it, the TV turns on and
switches to TV reception mode automatically.
(When you want to perform the turning on the power of TV
and the switching of the TV input simultaneously, press the
TV CONTROL ON button until its power is turned on, or
press the button again after the TV is turned on.)
If the TV input does not switch to the appropriate mode,
switch the input signal with the TV/VIDEO button.
Back ground operation ;
You can temporarily operate other components while
listening to/ watching a program source.
Press one of the numeric button" in which a function is
stored and an operation button at the same time while
pressing BACK GROUND button. The operative buttons are
VISUAL POWER, TV/VIDEO, CH PRESET +/-, ANT TV/
VTR, D.SKIP, B, ~<@l, 8, PP, <4, PPI, <4, 11, @.
Example: To record the CD being played on tapes.
* For stored functions in numeric buttons, see the table in
"Changing the Settings of the FUNCTION buttons".
Note
You can record only in the forward direction with back
ground operation.
Changing the Settings of the FUNCTION
sdb adelany
You can replace the functions stored in the FUNCTION
buttons.
Hold down one of the FUNCTION buttons you want to
change and press one of the numeric (1 to 0) buttons to select
the desired function.
After changing the setting of the FUNCTION button, the
equipment can be operated with the FUNCTION button you
have changed.
To return the function to the initial mode, perform the same
operation above.
With the numeric buttons from 1 to 0, each function can be
selected as described in the following table:
| Numeric buttons | The function to be selected
Example: To change the CD FUNCTION button to the DAT
function button.
Note
The settings of the TUNER button and the PHONO button
cannot be changed.
17