Table of Contents
Advertisement
Chapter 2 Basic Operations
Before operating the equipments with the remote
commander, be sure to set the receiver to the desired mode
by pressing one of the FUNCTION buttons.
The FUNCTION buttons are factory set in the following list.
eee
ee
cas
z
|
[rion | ees ont PHONO node)
¢ When VIDEO 1, 2 or 3 is pressed, the power of the
selected video equipment and TV is turned on.
Operating the equipment
1 Press the desired FUNCTION.
2 Press <4 (only for tape deck) or & to start playback.
Changing the settings of the FUNCTION
Buttons
With the SELECT button, you can replace the functions
stored in the FUNCTION buttons.
To change the settings of the FUNCTION buttons
1 Press one of the FUNCTION buttons to be stored.
2 Press SELECT.
.
3 Press the 1 to 9 button to select the desired function within
30 seconds.
4 Press ENTER.
To operate other unit temporarily without changing the
settings of FUNCTION
1 Press SELECT.
2 Press the 1 to 9 button to select the function.
3 Press the desired button.
After operating the unit, the receiver enters the previous
mode.
Operative buttons: POWER, </>,
</> Pi, 8, </P>, 11,
@REC, D.SKIP, TVVIDEO, ANT TVVTR, CH/PRESET
+/—-, SHIFT, INDEX.
Example:
To record the program source in DECK A in the CD mode
1 Press SELECT.
2 Press 3 (DECK A).
3 While pressing @, press REV or FWD.
After operating DECK A, the receiver enters the CD mode
automatically.
oler-ve-hitavemiuiiam dal-ma (cence) (om Oxelialattclale(cs
List of operative buttons in SYSTEM mode (When setting
the SYSTEM/TV selector to SYSTEM
A
a Dal De
cl CA
PC
e; The button is operative.
—: The button is not operative.
*: The button can operate TV and the VCR connected to TV.
Note
To operate the unit correctly, the function mode of the
receiver should be same with that of the remote
commander.
So, be sure to press the desired FUNCTION
button at first and then the operative button.
Advertisement
Table of Contents
