Table of Contents
Advertisement
Removing Excess Humidity
Remote Control
Control Panel
10
E-
If the atmosphere in your room is very humid or damp, you can remove
excess humidity without lowering the room temperature too much.
If necessary, press the
1
Result:
The air conditioner starts up in the Cool mode.
The unit beeps.
The air conditioner is fitted with a protection mechanism to pre-
vent the unit from being damaged when it is started immediately
after being:
Plugged in
Stopped
It will start up normally after three minutes.
If the temperature is not displayed on the control panel:
2
Press the
button on the remote control
or
Press the
button on the unit one or more times until the
temperature is displayed.
Result:
The unit beeps each time you press the
The air conditioner starts up in the Cool mode.
You can change modes at any time.
To adjust the temperature, press the
3
more times until the required temperature is displayed.
Possible temperatures are between 64°F and 86°F inclusive.
Result:
Each time you press the
- The temperature is adjusted by 1°F
- The unit beeps
The air conditioner starts removing the excess humidity;
the quantity of air is adjusted automatically.
To control the direction of the air flow, refer to page 11.
4
(On/Off) button.
or
buttons one or
or
buttons:
/
button.
Advertisement
Table of Contents
