Installation And Planning Notes; Installation Requirements; General Operating Conditions; Installation - Miele PWM 920 SI Installations Plan

en - Installation and planning notes
Installation on
concrete base
4

Installation requirements

The washing machine must be installed by Miele Service or by
properly trained staff of an authorized dealer.

This washing machine must be installed in accordance with all rel-
evant regulations and standards. Local energy supplier regulations
must also be observed.

This washing machine must only be operated in a room that has
sufficient ventilation and which is frost-free.
The washing machine should not be installed or operated in any
area where there is a risk of explosion.

General operating conditions

This washing machine is intended only for use in a commercial envi-
ronment and must only be operated indoors.
- Ambient temperature: 32-105°F (0-40°C)
- Relative humidity: non-condensing
- Maximum height above sea level of location site: 6500 ft (2000 m)
Depending on the nature of the installation site, sound emissions and
vibration may occur.
Tip: Have the installation site inspected and seek the advice of a spe-
cialist in instances where increased noise may cause a nuisance.

Installation

The washing machine must be set up on a level and firm surface with
the minimum stated load bearing capacity (see "Technical data").
The floor load created by the washing machine is concentrated and
transferred to the installation footprint via the machine feet.
Tip: A concrete floor is the most suitable installation surface for this
appliance. It is far less prone to vibration during the spin cycle than
wooden floorboards or a carpeted surface.
The washing machine requires a gap of at least 2" (50 mm) at each
side to allow for movement during operation. To ensure suitable ac-
cess for further maintenance and service work, please ensure a mini-
mum distance of 16" (400 mm) is maintained between the back of the
machine and the wall.
Machines with an integrated sampling valve must have a gap of at
least 8" (200 mm) on the left hand side.
The washing machine can be installed on a concrete base if desired.
The concrete materials and the durability of the concrete base must
be assessed in accordance with the floor load bearing capacity
given in "Technical data".