Cleaning And Storage - Toro 19-52ZX Operator's Manual

Cleaning and Storage

1. Disengage the PTO, set the parking brake, stop the
engine, and remove the key.
2. Remove grass clippings, dirt, and grime from the
external parts of the entire machine, especially the
engine. Clean dirt and chaff from the outside of the
engine cylinder head fins and blower housing.
Important
You can wash the machine with mild
detergent and water. Do not pressure wash the machine.
Avoid excessive use of water, especially near the control
panel, engine, hydraulic pumps, and motors.
3. Service the air cleaner; refer to Servicing the Air
Cleaner, page 24.
4. Grease and oil the machine; refer to Greasing and
Lubrication, page 29.
5. Change the crankcase oil and filter; refer to Engine Oil,
page 22.
6. Check the tire pressure; refer to Tire Pressure, page 29.
7. Charge the battery; refer to Servicing the Battery,
page 25.
8. Check the condition of the blades; refer to Cutting
Blades, page 30.
9. Prepare the machine for storage when non-use occurs
over 30 days. Prepare the machine for storage as
follows.
10. Add a petroleum based stabilizer/conditioner to the fuel
in the tank. Follow the mixing instructions from the
stabilizer manufacturer. Do not use an alcohol based
stabilizer (ethanol or methanol).
Note: A fuel stabilizer/conditioner is most effective when
mixed with fresh gasoline and used at all times.
A. Run the engine to distribute the conditioned fuel
through the fuel system (5 minutes).
B. Stop the engine, allow it to cool, and drain the fuel
tank; refer to Draining the Fuel Tank, page 28.
C. Restart the engine and run it until it stops.
D. Choke or prime the engine. Start and run the engine
until it will not start. Operate the primer, if
equipped, several times to ensure no fuel remains in
the primer system.
E. Dispose of fuel properly. Recycle as per local codes.
Important Do not store stabilizer/conditioned gasoline
over 90 days.
11. Remove the spark plug(s) and check its condition; refer
to Spark Plug, page 25. With the spark plug(s) removed
from the engine, pour two tablespoons of engine oil into
the spark plug hole. Use the starter to crank the engine
and distribute the oil inside the cylinder. Install the
spark plug(s). Do not install the wire on the spark
plug(s).
12. Clean any dirt and chaff from the top of the mower.
13. Scrape any heavy buildup of grass and dirt from the
underside of the mower, then wash the mower with a
garden hose.
14. Check the condition of the drive and mower belts.
15. Check and tighten all bolts, nuts, and screws. Repair or
replace any part that is worn or damaged.
16. Paint all scratched or bare metal surfaces. Paint is
available from your Authorized Service Dealer.
17. Store the machine in a clean, dry garage or storage area.
Remove the key from the ignition switch and keep it in
a memorable place. Cover the machine to protect it and
keep it clean.
38