Table of Contents
Advertisement
Here's how to change the setting:
Switch on ON/OFF switch (.
1.
Hold down the programme button
2.
# and then repeatedly press the
START button ` until •:‹...
appears in the display window.
Release both buttons.
3.
The LED of the # button flashes
and the digital display h lights up
to show the value •:‹....
Press the programme button #
4.
repeatedly until the value ˜:‹...
appears in the display window h.
Press the programme button 3.
5.
Each time the button is pressed, the
set value increases by one level;
when it reaches the value ˜:‹ƒ the
display jumps back to ˜:‹‹.
Press START button `.
6.
The set value is saved.
* depending on the features of your
dishwasher
Switching off the appliance
Shortly after the end of the
programme:
Switch off ON/OFF switch (.
1.
Turn off water supply (does not
2.
apply to appliances with Aqua-Stop).
Remove the utensils when they have
3.
cooled down.
When the programme ends,
Note:
leave the appliance to cool down a
while before opening it. This will prevent
steam from escaping and causing
long-term damage to your built-in
furniture.
Operating the appliance en
Interrupting the programme
Caution!
Expansion (overpressure) may cause
the appliance door to jump open and/or
water to escape! If the door was opened
on an appliance which has a hot water
connection or is heated, always leave
the door ajar for several minutes and
then close it.
Switch off ON/OFF switch (.
1.
The LEDs go out. The programme is
saved.
Switch on the ON/OFF switch (
2.
again to continue the programme.
Terminating the programme
(Reset)
Open the door.
1.
p r o g r a m m e
T e r m i n a t i n g t h e
Press the START button ` and
2.
hold it down for about 3 seconds.
The value ‹:‹‚ appears in the
display window h.
Close the door. The programme
3.
sequence lasts about 1 minute.
The value ‹:‹‹ appears in the
display window h.
Open the door.
4.
Switch off ON/OFF switch (.
5.
Close the door.
6.
Changing the programme
When the START button ` has been
pressed, the programme cannot be
changed. The only way a programme
can be changed is by Cancel
programme (Reset).
31
Advertisement
Table of Contents
