Table of Contents
Advertisement
en Operating the appliance
1
Operating the
appliance
Programme data
p l i a n c e
O p e r a t i n g t h e a p
The programme data (consumption
values) can be found in the quick
reference guide. They refer to normal
conditions and the set water hardness
value •:‹.... Different influencing factors
such as water temperature or line
pressure may result in deviations.
AquaSensor *
* depending on the features of your
A q u a S e n s o r
dishwasher
The Aqua sensor is an optical
measuring device (light barrier) which
measures the turbidity of the rinsing
water.
The AquaSensor is used according
to the programme. If the AquaSensor is
active, "clean" rinsing water can be
transferred to the next rinse bath and
water consumption can be reduced by
3–6 litres. If the turbidity is greater,
the water is drained and is replaced
with fresh water. In the automatic
programmes the temperature
and running time can also be adjusted
to the degree of soiling.
Switching on the appliance
Turn tap fully on.
1.
Switch on ON/OFF switch (.
2.
The Eco 50° programme has been
preset for environmentally friendly
operation whenever the appliance
starts. This programme remains
selected if no other programme
button 0 is pressed.
Press START button `.
3.
Programme sequence starts.
28
Note:
For ecological reasons the Eco 50°
programme is preset whenever the
appliance starts. This conserves
environmental resources and not least
saves you money.
The Eco 50° programme is a
particularly environmentally friendly
programme. According to EU
regulation 1016/2010 it is the
"Standard programme" which is the
most efficient standard cleaning cycle
for cleaning normally soiled utensils in
terms of the combined energy and
water consumption for cleaning these
types of utensils.
timeLight (optical display
while a programme is running)
*
* depending on the configuration of
t i m e L i g h t
your specific dishwasher
While a programme is running, an
optical display (additional programme
information) is projected onto the floor
at the bottom of the appliance door. If
the base panel is pulled forwards or if
the appliance is installed at eye-level
flush with the furniture then this display
will not be visible.
Possible settings of the optical
display:
†:‹‹ The display is switched off.
The display can show the
†:‹‚
/
programme, the timed delay,
remaining time and end of the
†:‹ƒ
programme.
The setting †:‹‚ is set up at the factory.
Advertisement
Table of Contents
