Table of Contents
Advertisement
NON-THROUGH
CUTS
See Figure 49.
WARNING:
Unplug the saw while removing or
replacing the blade guard. Tum on the saw with
the switch on the arm to confirm the blade is not
receiving power.
•
Remove the blade and blade guard (see Assembly
section).
•
Place a support the same height as the saw table
nearby for the cut work. Lower the blade with the
elevating handwheel.
•
Make sure the wood is not touching the blade,
Insert the key and turn on the saw, Let the blade
build up to full speed before contacting the work-
piece.
_1= WARNING:
Always use pushblocks when
making non-through rip cuts to avoid the risk of
serious injury, Never feed wood with your hands.
•
When the work is completed, press the switch off
and remove the key.
NON-THROUGH CUT
Fig. 49
53
CRRFI"SNRIr RADIAL SAW 315.220380
Advertisement
Table of Contents
