Opening/Closing The Enclosure - Emerson FB2100 Quick Start Manual

Opening/Closing the Enclosure

The enclosure opens/closes differently, depending upon whether you have the
compression-molded fiberglass enclosure or the aluminum enclosure.
EXPLOSION HAZARD: Never open the enclosure in a hazardous location. Opening the
enclosure in a hazardous location could result in an explosion.


DANGER
Compression-molded Fiberglass Enclosure
The enclosure includes two fasteners at the top and bottom of the door. To open
the door, lift the clasp to loosen the latch and pull it free of the post, then repeat for
the other fastener and open the door. To fasten the door, place the latch on the
post and press down the clasp; repeat for the other fastener.
Aluminum Enclosure
The enclosure includes six clamps along the edge of the door (two at the top, two
on the bottom, two at the side). To open the door, use a Phillips-head screwdriver
to loosen (but not remove) the screws enough so you can then pop the clamp free
of the lip of the door, then repeat for the other clamps and open the door. To
fasten the door, place the clamp over the door lip then tighten the screw; repeat
for the other clamps.
FB2100 Flow Computer Quick Start Guide
D301787X012
November 2023
3