Technical Data - Zanussi ZIT6470CB User Manual

Problem
The heat setting changes be‐
tween two levels.
The sensor fields become hot.
comes on.
comes on.
and a number come on.
You can hear a constant beep
noise.
8.2 If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an
Authorised Service Centre. Give the data
from the rating plate. Give also three digit
letter code for the glass ceramic (it is in the
corner of the glass surface) and an error

9. TECHNICAL DATA

9.1 Rating plate
Model ZIT6470CB
Typ 61 B4A 00 AA
Induction 7.35 kW
Ser.Nr. .................
ZANUSSI
14 ENGLISH
Possible cause
Power management operates.
The cookware is too large or you put
it too near to the controls.
Child Safety Device or Lock oper‐
ates.
There is no cookware on the zone.
The cookware is unsuitable.
The diameter of the bottom of the
cookware is too small for the zone.
There is an error in the hob.
The electrical connection is incor‐
rect.
message that comes on. Make sure, you
operated the hob correctly. If not the
servicing by a service technician or dealer
will not be free of charge, also during the
warranty period. The instructions about the
Service Centre and conditions of guarantee
are in the guarantee booklet.
PNC 949 595 676 00
220 - 240 V / 400 V 2N 50 - 60 Hz
Made in Germany
7.35 kW
Remedy
Refer to "Daily use".
Put large cookware on the rear zones,
if possible.
Refer to "Daily use".
Put cookware on the zone.
Use suitable cookware. Refer to "Hints
and tips".
Use cookware with correct dimen‐
sions. Refer to "Technical data".
Deactivate the hob and activate it
again after 30 seconds. If
on again, disconnect the hob from the
electrical supply. After 30 seconds,
connect the hob again. If the problem
continues, speak to an Authorised
Service Centre.
Disconnect the hob from the electrical
supply. Ask a qualified electrician to
check the installation.
comes