Table of Contents
Advertisement
ADJUSTmNG
BLADE GUmDE ASSEMBLY
See Figure 8.
WARNING:
To avoid personal injury, maintain proper
adjustment of blade tension, blade guides, and thrust
bearings.
To prevent the blade from twisting or breaking, the blade
guide assembly should always be set approximately
1/8
in. above the workpiece.
[] Turn the lock lever counterclockwise
to unlock the
blade guide assembly.
[] As a guide, use a scrap piece of the same wood you
are about to cut to set the height of the blade guide
assembly. Adjust blade guide assembly by turning the
blade guide knob.
[] Lock blade guide assembly in place by turning the lock
lever clockwise.
[] Always lock the blade guide assembly in place before
turning on the band saw.
mNSTALUNG
AND ADJUSTmNG
THE BLADE
See Figures 9 - 10.
_
WARNING:
Always wear safety goggles or safety
glasses with side shields to protect your eyes while
uncoiling band saw blades. Failure to heed this
warning could result in a serious eye injury.
[] Loosen and remove the wing nut and table aligning
bolt from the saw table.
[] Remove the saw table before opening the front cover
of the saw housing.
[] Loosen the two set screws that hold the blade guard in
place using the 4 mm hex key provided, then remove
the blade guard.
[] Turn the lock lever counterclockwise
to unlock the
blade guide assembly. Turning the blade guide knob
(clockwise raises the blade guide assembly; counter-
clockwise
lowers it), position the blade guide assembly
about halfway between the saw table and saw housing.
Retighten the lock lever.
[] Release blade tension by loosening the 8 mm hex nut
then turning the blade tension knob counterclockwise.
[] Carefully remove the old blade.
NOTE: The spring on the upper wheel allows the wheel
to be pulled down for easier removal of the blade.
[] Wearing gloves, carefully uncoi! the blade at arm's
length. If the new blade was oiled to prevent rust-
ing, it may need to be wiped to keep the oil from your
workpiece. Carefully wipe in the same direction the
teeth are pointing so the rag does not catch on the
teeth of the saw blade.
\
BLADE GUIDE
KNOB
LOCK
LEVER
WING
NUT
TABLE ALIGNING
BOLT
SETSCREWS
Fig. 8
SAW
TABLE
Fig. 9
14
Advertisement
Table of Contents
