Using The Self-Propel Drive; Bagging The Clippings; Stopping The Engine; Recycling The Clippings - Toro Recycler 20338 Operator's Manual

Using the Self-propel Drive

To operate the self-propel drive, squeeze the self-propel
drive bar (Figure 12) toward the handle and hold it.
1. Self-propel drive bar
To disengage the self-propel drive, release the self-propel
drive bar.
Note: The maximum self-propel ground speed is fixed.
To reduce the ground speed, increase the space between
the self-propel drive bar and the handle.

Stopping the Engine

To stop the engine, release the blade control bar.
Important: When you release the blade control
bar, both the engine and blade should stop within
3 seconds. If they do not stop properly, stop using
your mower immediately and contact an Authorized
Service Dealer.

Recycling the Clippings

Your mower comes from the factory ready to recycle the
grass and leaf clippings back into the lawn.
If the grass bag is on the mower and the bag-on-demand
lever is in the bagging position, move the lever
to the recycling position (refer to Operating the
Bag-on-Demand Lever) before recycling the clippings.
If the side-discharge chute is on the mower, remove it
(refer to Removing the Side Discharge Chute) before
recycling the clippings.
Figure 12

Bagging the Clippings

Use the grass bag when you want to collect grass and
leaf clippings from the lawn.
Note: Ensure the bag is seated in the correct position.
WARNING
A worn grass bag could allow small stones and
other similar debris to be thrown in the operator's or
bystander's direction and result in serious personal
injury or death to the operator or bystanders.
Check the grass bag frequently. If it is damaged,
install a new Toro replacement bag.
If the side discharge chute is on the mower, remove it
(refer to Removing the Side Discharge Chute) before
bagging the clippings. If the bag-on-demand lever is in
the recycling position, move it to the bagging position
(refer to Operating the Bag-on-Demand Lever).
WARNING
The blade is sharp; contacting the blade can result
in serious personal injury.
Stop the engine and wait for all moving parts to stop
before leaving the operating position.
Installing the Grass Bag
1. Raise and hold up the rear deflector (Figure 13).
1. Notches
2. Rear deflector
9
Figure 13
3. Grass bag pin (2)