Table of Contents
Advertisement
Operation
Switching the server on
The AC connected indicator lights up green (standby mode) when the server is
connected to the mains.
I
It will take about 60 seconds until the server can be switched on.
Ê Press the On/Off button.
The server is switched on, performs a system test and boots the operating
system.
I
In the case of configurations with a large memory size, the boot
process may be prolonged and the screen may remain dark for
several minutes.
Switching the server off
The power-on indicator lights up green.
Ê Shut down the operating system properly.
The server is switched off automatically and enters standby mode. The AC
connected indicator lights up green.
I
If the operating system does not turn off the server automatically, press
the On/Off button for at least four seconds and/or send a corresponding
control signal for power button override.
V
CAUTION!
There is a risk that data may be lost.
Other On/Off options
Besides the On/Off button, the server can be switched on and off in the following
ways:
– Timer-controlled turn-on/off
Using the ServerView Operations Manager or iRMC, you can configure that
the server is turned on/off controlled by an internal timer.
– Ring indicator
The server is turned on by an internal or external modem.
78
Operating Manual
TX2550 M5
Advertisement
Table of Contents
