Table of Contents
Advertisement
CHAPTER 3
Swap Floppy Drive
Switches the floppy disk drives between being designated as A
and B. Default is Disabled.
Boot Up Floppy Seek
During POST, BIOS will determine if the floppy disk drive installed
is 40 or 80 tracks. 360K type is 40 tracks while 760K, 1.2M and 1.44M are all
80 tracks.
Boot Up NumLock Status
The default value is On.
On (default)
Off
Gate A20 Option
Normal
Fast(default)
Typematic Rate Setting
Key strokes repeat at a rate determined by the keyboard controller.
When enabled, the typematic rate and typematic delay can be selected.
The settings are: Enabled/Disabled.
Typematic Rate (Chars/Sec)
Sets the number of times a second to repeat a key stroke when you
hold the key down. The settings are: 6, 8, 10, 12, 15, 20, 24, 30.
Typematic Delay (Msec)
Sets the delay time after the key is held down before it begins to
repeat the keystroke The settings are: 250, 500, 750, 1000.
Keypad is numeric keys.
Keypad is arrow keys.
The A20 signal is controlled by keyboard
controller or chipset hardware.
The A20 signal is controlled by port 92 or
chipset specific method.
3-10
AWARD
BIOS SETUP
®
Advertisement
Table of Contents
