Switching Off Heating Mode (Summer Mode); Protecting The Heating Installation Against Frost; Detecting And Rectifying Faults; Calling Up (Live Monitor) Status Codes - Vaillant ecoTEC plus VU 6/6-5 OVZ Series Operating Instructions Manual

Table of Contents

Advertisement

5 Detecting and rectifying faults

4.7 Switching off heating mode
(Summer mode)
Target flow temp.
Heating off
Cancel
1. To switch off heating mode without
switching off the hot water generation,
press
( ).
The value of the heating flow tem-
perature appears in the display.
2. Use the
button to set the heating
flow temperature to Heating off.
3. Confirm by pressing
Heating mode is switched off
The
symbol appears in the
display.
4.8 Protecting the heating
installation against frost
4.8.1 Frost protection function
Caution.
Risk of material damage due
to frost.
The frost protection function
cannot guarantee flow through
the entire heating installation,
which means that parts of the
heating installation may freeze
and therefore become dam-
aged.
During a period of frost, en-
sure that the heating installa-
tion remains in operation and
that all rooms are sufficiently
heated, even when you are
away.
12
If the heating flow temperature falls be-
OK
low 5 °C when the on/off button is on, the
product comes into operation and heats
the circulating water to approx. 30 °C on
both the heating side and the hot water
side (if available).
4.8.2 Draining the heating
Another way to protect the heating install-
ation and the product from frost for very
.
long switch-off times is to drain them com-
pletely.
5 Detecting and rectifying
6 Calling up (Live Monitor)
1. Press
2. Navigate to the Live monitor menu
Operating instructions ecoTEC plus 0020239012_02
Note
To keep the frost protection
devices active, you should switch
your product on and off using the
controller, if one is provided.
installation
Consult a competent person about this.
faults
If faults occur or fault messages are
displayed (F.xx), proceed as set out in
the table in the appendix.
Troubleshooting (→ Page 15)
If the product is not functioning cor-
rectly, contact a competent person.
status codes
and
at the same time.
The menu is called up.
item and press
.
The current operating status (status
code) is shown on the display.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ecotec plus vu 6/6-5 ovz h-gb seriesEcotec plus vu 126/6-5 ovzEcotec plus vu 126/6-5 ovz h-gbEcotec plus vu 156/6-5 ovzEcotec plus vu 156/6-5 ovz h-gbEcotec plus vu 186/6-5 ovz ... Show all

Table of Contents