Scanning Stored Stations With Preset Scan; Selecting The Seek Tuning Sensitivity; Stereo - Mono Switching; Loudness - Blaupunkt San Diego DJ I Operating Instructions Manual

Scanning stored stations with
Preset Scan
You can have all of the stored stations briefly
scanned.
To start Preset Scan:
• Press SCA/SRC for approximately
1 sec. until "SCAN" appears in the dis-
play.
All of the stored stations to be received in
the selected waveband will be scanned one
after the other. On FM, the radio will either
scan the stations stored on memory bank I
and II or T.
To select a scanned station and switch
off Preset Scan:
• Press SCA/SRC for about 1 second.
Note:
If "TA" shows on the display panel, the sys-
tem will scan the stored traffic stations only.
Selecting the seek tuning sensi-
tivity
You can alter the automatic seek tuning
sensitivity.
If "lo" is displayed, the radio will only pick up
strong, local stations.
If "lo" does not light up, the radio will also
pick up weaker, distant stations.
Should you wish to alter the seek tuning
sensitivity, refer to chapter "DSC program-
ming – LO/DX".

Stereo - mono switching

The radio will only play in stereo if the ster-
eo quality of the received station signal is
sufficient.
When the signal strength gets poor, the ra-
dio will gradually switch to mono.
You can select between stereo or mono
sound in the DSC menu.
For more information, refer to chapter "DSC
programming – STEREO/MONO".
Each time the radio is switched on, stereo
sound is activated automatically.

Loudness

Adjusts the low bass frequencies for a more
natural sound.
Switching Loudness on/off:
• Press the AUD button for approximate-
ly 1 sec.
When the Loudness function is active, "LD"
will light up in the display.
See chapter "DSC programming" for more
information.
31