Download Print this page

Safety Instructions; To Reduce The Risk Of Fire, Electric Shock, Or Injury To Persons, Observe The Following - Thermador CVS236CS Installation Manual

Downdraft

Advertisement

Available languages

Available languages

Read All Instructions Before Using the Appliance.
WARNING
TO REDUCE THE RISK OF FIRE,
ELECTRIC SHOCK, OR INJURY TO
PERSONS, OBSERVE THE
FOLLOWING:
A. Installation work and electrical wiring
must be done by qualified person(s) in
accordance with all applicable codes
and standards, including fire-related
construction.
B. Sufficient air is needed for proper
combustion and exhausting of gases
through the flue (chimney) of fuel
burning equipment to prevent back-
drafting. Follow the heating equip-
ment manufacturer's guideline and
safety standards such as those
published by the National Fired
Protection Association (NFPA), and
the American Society for Heating,
Refrigeration and Air Conditioning
Engineers (ASHRAE), and the local
code authorities.
C. When cutting or drilling into wall or
ceiling, do not damage electrical
wiring and other hidden utilities.
D. Ducted fans must always be vented
to the outdoors.
E. Always unplug or disconnect the
downdraft from the power supply
before servicing.
F. This unit is designed for indoor use
only. Use this unit only in the manner
intended by the manufacturer.
This unit is manufactured for indoor use
only. Do not use this unit outdoors.

SAFETY INSTRUCTIONS

READ AND SAVE THESE INSTRUCTIONS
WARNING
CAUTION: For general ventilating use
only. Do not use to exhaust hazardous or
explosive materials and vapors.
To reduce risk of fire and to properly
exhaust air, be sure to duct air outside.
Do not vent exhaust air into spaces
within walls, ceilings, attics, crawl spaces
or garages.
TO REDUCE THE RISK OF FIRE, USE
ONLY METAL DUCT WORK.
To reduce the risk of fire, electric shock
and injury to persons, ventilator
assemblies. All CVS2 models must be
installed with integral blower, Model
VTN600CV2C or remote blowers model
VTR600R or VTR1000Q. Other ventilator
blowers cannot be substituted.
To reduce the risk of fire or electric
shock, do not use the fan with any solid-
state speed control device.
This appliance has been found to be in
compliance with UL 507 Standard for
Electric Fans and CAN/CSA-22.2 No.
113 Canadian Standard for Fans and
Ventilators. It is the responsibility of the
owner and the installer to determine if
additional requirements or standard
apply in specific installation.
3

Advertisement

loading

This manual is also suitable for:

Ucv230dsCvs2Ucv2