Table of Contents
Advertisement
At the fringe areas of reception, both voice and tone quality
will start to sound "garbled" or "broken". To correct this
problem, simply position the accessory and radio closer to
each other (within the 10 meter defined range) to re-
establish clear audio reception.
NOTICE:
Once a COTS headset is paired to your radio, it is
always connected. Therefore the battery life of the
accessory is aligned with the Talk Time power
consumption, not the Standby Time consumption.
Turn on the accessory. Then, place it close to the
radio aligning the Bluetooth Pairing Location (a blue
dot) on the radio to the Bluetooth Pairing Location (a
blue dot) on the accessory.
If the pairing process is successful, you hear an
incremental-pitched tone. The radio begins to
connect to the device.
If the pairing process fails, you hear a short, low-
pitched tone. The display shows Bluetooth
pairing failed. Repeat this step.
The radio tries to establish connection with the device once
paired.
NOTICE:
If the connection fails within 6 seconds, you hear a
decremental-pitched tone to indicate that the device
is unpaired. The display shows <Device Type>
unpaired. Repeat this step to re-initiate the pairing
process.
If the connection is successful, you hear an incremental-
pitched tone. The display shows <Device Type>
connected and the Bluetooth icon turns from
If the radio has the pairing record of the device and the
connection fails, you hear a short, low-pitched tone. The
display shows <Device Type> connect failed.
Radio Indications of Lost Bluetooth
Connection
The radio shows
when the device has a Bluetooth
connection. Below are the radio indications when the
connection is interrupted.
The
starts blinking for up to 10 seconds. You hear a
decremental-pitched tone. The display shows <Device
Type> alternating with disconnected.
English
to
.
165
Advertisement
Table of Contents
