Connecting The Touch Module - BenQ RP8603 User Manual

18
Connections

Connecting the touch module

Connect the TOUCH-USB port on the display to the USB port of a computer using
the supplied USB cable. The touch module of the display supports easy Plug-and-Play
operation. There is no need to install additional drivers on the computer.
• Connect TYPE-C port with the computer.
• HDMI must be used with TOUCH-USB at the front panel.
• HDMI 1 or DP must be used with the TOUCH-USB next to HDMI 1.
• HDMI 2 or VGA must be used with the TOUCH-USB next to HDMI 2.
VGA
• Avoid blocking the touch screen frame (where sensors are located) when initiating the touch
module.
• If any ghost image occurs, please try to un-plug and then re-plug all USB cables. If the failure image
still exists, use another USB Type-B to Type-A cable.
• It is highly recommended that you connect the display to the PC or laptop directly. Please be
noted that using a faceplate device or an extender may cause failures in touch operations since
the display quality can be affected by many uncertainties such as cable grade, cable quality, source
and destination equipment, RF and electrical interference, and cable patches.
HDMI2 TOUCH-USB DP HDMI1 TOUCH-USB
TYPE-C HDMI
TOUCH-USB