Advertisement
INSTALLATION
ASSEMBLE TANK BOLTS&WASHERS
Slip bolt heads into mounting hole on bottom of tank. Place
large foam washer on base of flush valve.
Place tank on bowl and attach with nuts and washers from
under bowl.
See Fig.#2b.
NOTE: Do not use white cement or high lime content
cements to install this toilet. The expansion of cement due to
a rise in temperature may make the toilet crack or cause
damage. Kohler is not responsible for any damage caused by
installation with the use of cement.
Fig.#2a
2a
INSTALL THE BOWL
1. Put the bowl in position and mark a line along the back of
the bowl.
2. Place the template on the floor, align to the pencil line and
secure to the floor.
3. Drill the fixing holes with a 10 mm drill as indicated on the
template.
CAUTION: Please make sure there is no water pipe or
spool under the holes to be drilled.
4. Fit the clamps to the floor with the floor plugs, washers and
nuts.
5. Position the bowl and install the soil pipe in accordance
with the manufacturer's instructions.
Note!
An inlet isolating valve must be installed to the bowl.
6. Connect the inlet water supply to the bowl.
7. Secure the bowl in positon with the plastic sleeve and the
screw. Fit the plastic cover cap.
1131873-T01-G
See Fig. #2a.
Fig.#2
2
1.
2.
3.
4.
5.
6.
7.
-3-
2a
2b
Tank
Attachment wing nuts
Fig.#2b
2b
10mm
Bowl
Advertisement
