Setting The Automatic Gain Control (Agc); Setting The Noise Reduction (Nr) - JRC JSS-2150N Instruction Manual

Operation
4.3.3

Setting the automatic gain control (AGC)

■ ■
Procedure
1 1 . .
1 .
Press the
MENU
hierarchical menus, select 5.4 Receiver.
2 2 . .
2 .
Select 1. Auto gain control and press ENT,
when the cursor moves to the right use the jog
dial to select Slow, Fast, or OFF.
After selecting and pressing ENT, the
settings are complete.
Note The same settings can be done by pressing and holding the
5
AGC
4.3.4

Setting the noise reduction (NR)

■ ■
Procedure
1 1 . .
1 .
Press the
MENU
hierarchical menus, after 5.4 Receiver
appears, move the cursor to 2. Noise
reduction.
2 2 . .
2 .
Press ENT to move the cursor to the right,
then use the jog dial to select NR1, NR2,
BC, or OFF.
After selecting and pressing ENT, the
settings are complete.
-
The various settings are shown below.
Note
・ NR1： Noise reduction (low)
・ NR2： Noise reduction (high)
・ BC：
-
The same settings can be done by
pressing and holding the
and the
-
This function is invalid in DSC mode or
telex mode. Moreover, the beat
canceller becomes invalid in CW mode.
4-30
key, and through
key at the same time.
key, and through
Beat canceller
3 key at the same time.
NR
5.4)Receiver
1.Auto gain control
2.Noise reduction
3.Attenuation
4.Clarifier
5.Squelch
6.CW bandwidth
7.Scan
0.Back
5.4)Receiver
1.Auto gain control
2.Noise reduction
3.Attenuation
4.Clarifier
5.Squelch
6.CW bandwidth
7.Scan
0.Back
5.4)Receiver
1.Auto gain control :Slow
2.Noise reduction
3.Attenuation
4.Clarifier
5.Squelch
6.CW bandwidth
7.Scan
0.Back
5.4)Receiver
1.Auto gain control :Slow
2.Noise reduction
3.Attenuation
4.Clarifier
5.Squelch
6.CW bandwidth
7.Scan
0.Back
FUNC key
:Slow
:OFF
:OFF
:+000Hz
:OFF
:Narrow
:Fast
:OFF
:OFF
:+000Hz
:OFF
:Narrow
FUNC key and the
:OFF
:OFF
:+000Hz
:OFF
:Narrow
:NR1
:OFF
:+000Hz
:OFF
:Narrow