Craftsman 315.275 Owner's Manual page 16

LIGHT BULB REPLACEMENT
See Figure 17.
A
c
E
Fig. 17
• Unplug your router.
_, WARNING: Failure to unplug your router
could result in accidental starting causing
serious injury.
• Remove cutter from router. Refer to page 8 to
remove cutter.
• Adjust router to maximum height.
• Remove screws (A) and subbase (B).
See Figure 17.
• Remove screw (C) and work light lens (D).
• With bulb (E) pointing toward you, pull bulb from
socket.
• Install new bulb by reversing the above procedure.
• Reassemble all parts and tighten screws securely.
PROPER CARE OF cu'n'ERS
Get faster more accurate cutting results by keeping
cutters clean and sharp. Remove all accumulated
pitch and gum from cutters after each use.
When sharpening cutters, sharpen only the inside of
the cutting edge. Never grind the outside diameter. Be
sure when sharpening the end of a cutter to grind the
clearance angle the same as originally ground.
PROPER CARE OF COLLET
From time to time, it also becomes necessary to clean
your collet and collet nut. To do so, simply remove
collet nut from collet and clean the dust and chips that
have collected. Then return collet nut to its original
position.
HELPFUL HINTS
,/ Always clamp workpiece securely before routing.
•/ A safe operator is one who thinks ahead.
,/ Always wear eye protection when routing.
,/ Make setup adjustments carefully. Then double
check. Measure twice and cut once.
,/ Keep cutters clean and properly sharpened.
,/ Don't let familiarity make you careless.
,/ Study all safety rules and do the job safely.
J" Never place your hands in jeopardy.
J Make certain clamps can't loosen while in use.
,/ Test difficult setups on scrap-- Don't waste lumber.
,/ Plan each operation before you begin.
,/ Provide for smoother operation by cleaning your
router frequently. Shake router or blow with an air jet
to remove sawdust buildup.
•/ Think safety by thinking ahead.
16