Setting And Checking Date And Time - Nikon E2 Instruction Manual

Setting and checking date and time
You can check the current data by pushing the DATE button.
The display in th e LCD panel changes in th e following order:
Year, Month, Day , Hou r, and Minute as you push the DATE
button.
To correct the data, adjust in the following way.
-You cannot check and adjust the data when the Main dial is set to PB.
1
Press the shutter release button
halfway and push the DATE button.
Push the DATE button for at least one
second so that the "year " section starts to
blink . Next remove your finger from the
shutter release button .
2
Rotate the command dial to set the
correct "year" and push the DATE
button.
Rotate the command dial counter-clockwise
to increase the setting values, and rotate
clockwise to decrease the setting values .
Then push th e DATE button again , and the
"month " section starts to blink .
3
Follow the same procedure to set the "month," "day," "hour"
and "minute."
Rotate the command dial to set the correct "month ", "day ," "hour" and
"minute ," and push the DATE button . When the "minute " is set and the DATE
button is pushed , the clock starts working .
- The clock only starts working from 00 sec. when the "minute " setting is
correc ted.
- If the camera is left untouched in the date/ time setting mode for more than
90 seconds, the LCD panel returns to the normal display mode.
-If the shutter is released while date/ time setting is in progress, the
date/ time setting mode will be canceled, and all data set will be invalid.
23
I