Remote Control Operation (Optional) - Nikon N75 Instruction Manual

Remote Control Operation (optional)
Use the optional remote c o ntrol to release the camera's shutter from a
distance. A s with self-t imer operatio n, the remote contro l can also be used
w hen y o u want to be in the p hotograph . Yo u can also use t he remote co ntrol
instead of a cab le release to reduce camera shake.
· ................................................... .
NOTE: Before using the remote control
When using the remote control for the first time, make sure to pull out the insulation
sheet placed on the battery inside the remote control unit that is set when purchased.
1
Press the @ remote control button a
number of times so
~
(immediate release)
or
0
(two-sec. delay release) appears in
the LCD panel.
(Or, rotate the Command Dial
while pressing t he
@)
rem ote control button.}
The display changes as follows:
•
~
=
(9 -+ ~ -+ ~ -+
L
Self-timer
No display
(cancel)
• You can choose to release the shutter either immediately after
(~)
or two sec. after
(~)
the shutter release button on the remote control unit is pressed.
• Once remote control operation is set, the camera remains ready to receive a signal
from the remote control unit for 1 min. If no signal is sent for 1 min., the remote control
mode is canceled and
~
or disappears from the LCD panel.
• The remote control cannot be operated unless the camera's shutter can be released
(i.e. when subject is not in focus with autofocus).
• After the shutter is released , the camera remains ready to receive another signal from
the remote control unit for 1 minute.
001'ffilll
:a :
Standby duration for the remote control operation can be changed to 5 or
10 min. (p.76).
84