Operation And Display Section For Remote Control; Current Time Setting - Mitsubishi SRR60ZJ-S User Manual

Operation and display section for remote control

Operation section
Each time the button is pressed, the
display is switched over in turn.
Page 8
Page 13
These buttons set the room temperature.
(These buttons are used for setting the
current time and timer function as well.)
Page 11
Page 10
Page 14
Transmission procedure
When each button on the remote control is pressed – with the remote control pointing towards the air-conditioner unit a signal is transmitted.
When the air-conditioner receives the signal correctly, it will beep.

Current time setting

■ When inserting the batteries, the current time is automatically set to time setting mode.
13:00 is displayed as the current time. Set the clock to the right time.
Example: Set to 10:30.
1
Press the ACL switch.
Press with the tip of a ballpoint pen, etc.
The time display blinks and can be set to the current time.
2
Press the " or
(Set to 10:30)
3
Press the ON/OFF button.
The display changes from blinking to steady lighting and the setting is complete.
Make sure to press the button within 60 seconds from the last operation in step 2,
otherwise the time is not set.
NOTE
• The timer operation works based on the time clock, so please set it correctly.
• The remote control data is reset when the present time is set.
– 7 –
Each time the button pressed, the
display is switched over in turn.
Press to start operation, press again to
stop.
This button changes the air flow (up/down)
direction.
This button is not used.
(Air flow direction adjustment can not be
performed.)
ACL switch
This switch is for resetting microcomputer
and setting time.
" button.
Page 8, 9
Page 12
Page 10
Page 6