Table of Contents
Advertisement
Models SRK10CRS-S, S1, S2, S3, S4, S5, S6
Operation and indication section for remote control
SRK13CRS-S, S1, S2, S3, S4, S5, S6
SRK10YJV-S
Remote control
SRK13YJV-S
◆ Operation section
Operation section
FAN SPEED button
Each time the button is pushed, the
indicator is switched over in turn.
HI POWER/ECONO button
This button changes the HIGH POWER/
ECONOMY mode.
TEMPERATURE button
This button sets the room temperature.
(This button changes the present time and
TIMER time.)
ON TIMER button
This button selects ON TIMER operation.
SLEEP button
This button changes to SLEEP operation.
CLEAN switch
This switch changes the CLEAN mode.
Indication section
Unit display section
CLEAN indicator
Indicates during CLEAN operation.
SLEEP indicator
Indicates during SLEEP operation.
TEMPERATURE indicator
HI POWER light (green)
Indicates set temperature.
(Does not indicate temperature when operation
Illuminates during HIGH POWER operation.
mode is on AUTO)
3D AUTO light (green)
FAN SPEED indicator
Illuminates during 3D AUTO operation.
Indicates set air flow rate with
How to open the air inlet panel
HI POWER/ECONO MODE indicator
Place fingers at the recesses on both sides of the panel and pull up the panel
Indicates during HIGH POWER/ECONOMY
to this side so that it will be opened by about 60 degrees.
mode operation.
Transmission procedure
When each button on the remote control is pressed with the remote control pointing towards the air-conditioner unit a signal is transmitted.
When the air-conditioner receives the signal correctly, it will beep.
How to close the air inlet panel
Push both sides evenly and press further lightly at the center.
The above illustration shows all controls, but in practice
only the relevant parts are shown.
lamp.
– 7 –
-
ON/OFF TIMER indicator
Illuminates during operation
Indicates during ON/OFF TIMER operation.
and CLEAN operation.
Illuminates during TIMER operation.
OPERATION MODE indicator
Indicates selected operation with
[
(Auto)
Indicates present time or timer setting time.
Shows selected flap and louver mode.
Unit ON/OFF button
In emergencies, this button can be used for turning on/off the unit when
Indicates during 3D AUTO operation.
remote control is not available.
-
'15 • SRK-T-172
OPERATION MODE select button
Each time the button pushed, the
indicator is switched over in turn.
ON/OFF (luminous) button
Press for starting operation, press again
for stopping.
AIR FLOW (UP/DOWN) button
This button changes the air flow (up/down) mode.
AIR FLOW (LEFT/RIGHT) button
This button changes the air flow (left/right) mode.
3D AUTO button
This button sets 3D AUTO operation.
OFF TIMER button
This button selects OFF TIMER operation.
ACL switch
Switch for resetting microcomputer and
setting time.
CANCEL button
This button cancels the ON timer, OFF
timer, and SLEEP operation.
RUN light (green)
TIMER light (yellow)
lamp.
(Cool)
(Fan)
(Dry)]
TIME indicator
AIR FLOW indicator
3D AUTO indicator
Page 15
Unit ON/OFF button
Hide quick links:
Advertisement
Table of Contents
