Table of Contents
Advertisement
Level of protection against ingress of solid particles and moisture ensured
by the protective cover, except where the low voltage equipment has no
protection against moisture
Water supply pressure
1)
Water supply
Maximum Load
Spin Speed
1)
Connect the water inlet hose to a water tap with a 3/4'' thread.
5. INSTALLATION
WARNING!
Refer to Safety chapters.
5.1 Unpacking
1. Open the door. Remove all the items from
the drum.
Accessories delivered with the
appliance may vary depending on the
model.
2. Put the packaging element on the floor
behind the appliance and carefully put it
down onto its rear side. Remove the
polystyrene protection from the bottom.
8
ENGLISH
Minimum
Maximum
Cotton
Maximum spin speed
Do not lay washing machine on its front.
3. Put the appliance back into an upright
It is possible to see water flowing
from the drain hose. This is because
the washing machine has been
tested at the factory.
4. Remove the three bolts by using the key
IPX4
0.5 bar (0.05 MPa)
10 bar (1.0 MPa)
Cold water
10 kg
1351 rpm
1
CAUTION!
position. Remove the power supply cable
and the drain hose from the hose holders.
WARNING!
supplied with the appliance. Pull out the
plastic spacers.
2
Advertisement
Table of Contents
