Table of Contents
Advertisement
3-3. Installation of the thread stand
(1) Assemble the parts (No.1 to No.11) of the thread stand as shown on the figure.
(2) Fit the thread stand into the hole at the far right on the table stand with the nut (No.13) and the washers
(No.12).
<9>
<6>
<5>
<4>
<3>
<7>
<8>
3-4. Installation of the eye guard
(1) Loosen the screws (No.2) on the eye guard unit (No.1) then, mount the screws (No.3) to the flat place
of the sewing machine with the open guard.
(2) Return the open guard to the initial position then, tighten the screws (No.2).
<2>
<1>
<3>
<1>
<10>
<1>: Upper column pipe
<2>: Lower column pipe
<3>: Spool stand base (two stand bases)
<4>: Spool mat (two mats)
<5>: Spool holder (two holders)
<6>: Spool shaft (two shafts)
<7>: Spring washer (two washers)
<11>
<8>: Nut (four nuts)
<9>: Thread hunger
<10>: Spool holder
<2>
<11>: Column joint
<12>: Washer (two washers)
<13>: Nut
<12>
<13>
<1>: Eye guard unit
<2>: SW-MW screw
<3>: SW-PW screw (two screws)
- 4 -
Advertisement
Table of Contents
