Table of Contents
Advertisement
B-2
Loosen this Socket
Head Screw to Adjust
Faceplate Angle
5/16"
Allen
Wrench
Cross Seam Adjuster
Loosen to Rotate
Entire Head Around
Mounting Axis
With K29
Loosen Screw
OPERATION
FIGURE B.1 - FEED HEAD ADJUSTMENT
The Cross Seam Adjuster
Can Be Mounted to the
Top or Bottom of the
Face-plate Rotates
360° Around the
Drive Roll Shaft
FIGURE B.2 - HORIZONTAL ADJUSTMENT
MAXsa 29
2 1/2"
FIGURE B.3 - VERTICAL ADJUSTMENT
Use This Screw
To Lock Vertical
Position
With Standard Mounting (M6767)
or K29 Vertical Adjuster
MAXSA™ 22 & 29 WIRE DRIVES
Gear Box
Feed Head Rotates
360° Around the
Motor Axis
This Adjustment Can be
Locked by Tightening
Two Socket Head Screws
MAXsa 22
2"
K96 Horizontal Adjuster
K29 Clamps Can Be Set
to Restrict In and Out Motion
to Distances up to 3 3/4"
Turn Handle
to adjust
Rotating the K96 Allows
for 2" Movement in
any Direction in the
Horizontal Plane
Head May Be Rotated
Around the Vertical Axis
K96
Head
Mounting
With Standard Mounting (M6767)
or K96 Horizontal Adjuster
B-2
Advertisement
Table of Contents
