Table of Contents
Advertisement
Step
13. Engine oil
14. Transmission gear oil
15. Rear differential gear oil
16. Engine coolant
17. Clutch fluid
18. Window washer fluid
19. Front hood latch
20. Keyless entry system
21. Keyless access function
22. Security system
23. Seat
24. Seat belt
25. TPMS (U.S. model)
26. Grommet installation
27 Horn
28. Hazard lights
29. Map light
Checks with the engine running
Step
30. Delivery mode connector
31. Immobilizer system
32. Starting condition
33. Exhaust system
34. Indicator and warning lights
35. Heater & ventilation
36. Air conditioner
37. Clock
38. Antenna
39. Audio
40. Navigation
41. Accessory power supply socket
42. Lighting system
43. Vehicle stability control (VSC)
44. Illumination control
45. Window washer
46. Wiper
47. Power window
48. Rear defogger
49. Door mirror
50. Parking brake
51. Diagnostic trouble code (DTC) check
Pre-delivery Inspection
Check the engine oil amount.
Check for leakage of the transmission gear oil.
Check for leakage of gear oil from the rear differential.
Check the engine coolant level.
Check the clutch fluid amount.
Check the window washer fluid amount.
Check that the front hood is closed normally and locked securely.
Check that the keyless entry system operates normally.
Check that the keyless access function operates normally.
Check that the security system operates normally.
1. Check the seat surfaces for stains or dirt.
2. Check the seat installation conditions and functionality.
Check the seat belt installation conditions and functionality.
Check that the TPMS warning light operates normally. If it does not operate
normally, perform the diagnosis by referring to TPMS (Diagnosis).
Install the grommet contained in the glove box to the tie-down hole.
Check if the horn sounds.
Check that the hazard lights illuminate.
After installing the fuse, check that the map light illuminates/turns off nor-
mally.
Install the delivery mode connector.
1. Check that the engine starts with all keys that are equipped on vehicle.
2. Check if the security indicator light operates normally.
Start the engine and check that the engine starts smoothly.
Check that the exhaust noise is normal and no leaks are found.
Check that all indicator lights and warning lights are operating correctly.
Check that the heater & ventilation system operates normally.
Check that the air conditioner operates normally.
Check that the clock operates normally.
Install the antenna.
Check that the radio, CD and audio (including AUX) operate normally.
Check the navigation and AUX operate normally.
Check that the accessory power supply socket operates normally.
Check that the lighting system operates normally.
Check the VSC SPORT and VSC OFF switch functions for normal operation.
Check that the illumination control operates normally.
Check that the window washer system operates normally.
Check that the wiper system operates normally.
Check that the power window operates normally.
Check that the rear defogger operates normally.
Check that the remote control mirror and heated mirror operate normally.
Check the parking brake for normal operations.
Check that the diagnostic trouble code (DTC) is not detected.
PI-3
PRE-DELIVERY INSPECTION
Check point
Check point
Advertisement
Table of Contents
