Table of Contents
Advertisement
EN 12
4.
TPS10.1A LA
4.3.3
Small Signal Board (SSB)
Refer to
Figure 4-6
for details.
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the SSB.
1. Release the clips from the LVDS connector that connect
with the SSB [1].
Caution: be careful, as these are very fragile connectors!
Unplug the cable/flat foils connector.
2. Unplug all other connectors [2].
3. Remove all the fixation screws from the SSB [3].
4. Take out the SSB with I/O bracket.
5. The SSB can now be shifted away from side connector
cover, then lifted and taken out of the I/O bracket. Refer to
Figure 4-6
for details.
2013-Jul-05
Mechanical Instructions
Figure 4-5 Rear cover removal
4.3.4
back to
div. table
2
3
Figure 4-6 SSB removal
Power Supply Unit (PSU)
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the PSU.
1. Unplug all connectors from the PSU.
2. Remove all fixation screws from the PSU.
3. The PSU can be taken out of the set now.
1
19450_106_130112.eps
130112
3
1
3
19450_109_130116.eps
130130
Advertisement
Table of Contents
