Settings - Cambridge Audio C10973 Manual

28

Settings

Last updated: September 2, 2022 12:51. Revision #8102
Device Name
This is how your player will appear in your StreamMagic app and on your home network when using services like Spotify, Chromecast built-in and
TIDAL Connect.
Giving your player a unique name makes it easier to distinguish when using streaming and smart home services.
AirPlay Name
This is how your player will appear when using AirPlay or the Apple Home app.
Standby Mode
This selects what type of standby mode your player will use.
In Network Standby mode your player will still be controllable by the StreamMagic app and other network services
In Eco mode your player will use less power than in Network Standby mode, but will need to be switched on either by the front panel or the remote
control before it can be seen and controlled by the StreamMagic app and other services.
Automatic Power Down
This sets how long your player will wait while inactive before switching in to standby.
Display Brightness
This sets the brightness of your player's display. If set to 'Off' the display will show for a few seconds after any change and then switch off.
Pre-amp
With Pre-Amp mode enabled the volume of the device's analogue output can be controlled using the app, the remote or the rotary dial.
For more information see our FAQ.
Volume Limit
This sets the maximum volume that other streaming services like AirPlay, Spotify, TIDAL Connect and Chromecast built-in can set. The front panel,
remote control and StreamMagic app volume controls can override this setting.
Early Update
Early Updates provide the opportunity to receive pre-release firmware for your EDGE NQ. To subscribe to Early Updates, select On, and to opt out
select Off.
Note: Information on what is included in the current early update for the EDGE NQ can be found here.